Post
by jcoco3 » Wed Apr 17, 2019 11:47 am
I would say its a bit easier than previous models as you don't need a port number or other syntax.
On the scanner turn on wifi from general settings and make sure it is set to "access point" if you want to connect your remote device directly to the scanner. Note the ip on the wifi settings screen of the scanner, then connect your device to the scanners wifi. Open up a browser and enter the ip in the address bar. The scanner's interface should pop right up on the remote device.
You also have the option to use the scanner in wlan mode, which allows you to connect it to an existing wifi network from which the scanner can be controlled from any browser capable device on that network. It is a handy feature when the direct access point mode has too much interference from other wifi signals. There are more tricks and neat things to talk about here, but that should get you going.
Don't know if there is an existing video. I can make a quick one if neccessary.