Hi,
When scanning to model to a bim model, do you guys scan at different resolutions f.e. for lod 200 or lod 400. Or do you scan like always and deliminate in recap or other software?
Bim LOD specs
- landmeterbeuckx
- V.I.P Member
- Posts: 1616
- Joined: Tue May 01, 2012 5:19 pm
- 11
- Full Name: Lieven Beuckx
- Company Details: Studiebureau Beuckx
- Company Position Title: Owner
- Country: Belgium
- Linkedin Profile: Yes
- Has thanked: 183 times
- Been thanked: 548 times
-
- V.I.P Member
- Posts: 158
- Joined: Fri Nov 13, 2009 10:12 am
- 14
- Full Name: simon judd
- Company Details: Precision Air Surveys Limited
- Company Position Title: Owner
- Country: United Kingdom
- Been thanked: 3 times
Re: Bim LOD specs
Hi
Field operation does not change for us.
Better to capture all and use less to create the model to your specific client requirements (LOD etc) than to capture less and need more!!
Also if the requirements do change (which invariably they will) you will have additional data to analyse and up-spec the model as required.
Simon
Field operation does not change for us.
Better to capture all and use less to create the model to your specific client requirements (LOD etc) than to capture less and need more!!
Also if the requirements do change (which invariably they will) you will have additional data to analyse and up-spec the model as required.
Simon
- landmeterbeuckx
- V.I.P Member
- Posts: 1616
- Joined: Tue May 01, 2012 5:19 pm
- 11
- Full Name: Lieven Beuckx
- Company Details: Studiebureau Beuckx
- Company Position Title: Owner
- Country: Belgium
- Linkedin Profile: Yes
- Has thanked: 183 times
- Been thanked: 548 times
Re: Bim LOD specs
Thought the same actually. Do you adjust your point spacing accordingly and in case of more detail discuss a additional quote for that?