Hi,
Just a quick question when registering traversed p40 data in cyclone.
Basically i need to run off first floor scans seperatly from my ground floor scans, but i need to pull through stations from the ground floor scans to tie in the first floor.. any easy way of doing it without writing down co ordinates to import a new target file
Registering Traversed P40 Data
-
- I have made 10-20 posts
- Posts: 17
- Joined: Thu Oct 04, 2018 8:48 pm
- 5
- Full Name: David ison
- Company Details: Castle Surveys
- Company Position Title: Senior Surveyor
- Country: England
- Linkedin Profile: No
- Phil Marsh
- Administrator
- Posts: 2490
- Joined: Sun Aug 12, 2007 2:28 pm
- 16
- Full Name: Phil Marsh
- Company Details: Laser Scanning Forum Ltd
- Company Position Title: Director
- Country: UK
- Skype Name: phil.h.marsh
- Linkedin Profile: Yes
- Location: Barnsley, UK
- Has thanked: 119 times
- Been thanked: 36 times
- Contact:
-
- I have made 10-20 posts
- Posts: 17
- Joined: Thu Oct 04, 2018 8:48 pm
- 5
- Full Name: David ison
- Company Details: Castle Surveys
- Company Position Title: Senior Surveyor
- Country: England
- Linkedin Profile: No
Re: Registering Traversed P40 Data
Phil,
I'm not sure if he did.
I got around it by just deleting out the unwanted scans in the model space, but i know there is an easier way.
I'm not sure if he did.
I got around it by just deleting out the unwanted scans in the model space, but i know there is an easier way.