Hi,
I'm new to 3DR.
I work in mining and we get often to fly the drone with RTK to check that the batter of the open pit are pulled to design.
I know how to create a heatmap to show undercut or overcut, but I can't find the way to show the volume of the material for these areas.
Thanks in advance for the help. Hopefully someone could explain step by step the procedure to create a cut/fill report.
Drone pick up against design cut/fill calculation
-
- I have made <0 posts
- Posts: 1
- Joined: Fri Jun 17, 2022 2:55 am
- 1
- Full Name: Andrea Nguyen
- Company Details: none
- Company Position Title: Surveyor
- Country: Australia
- Linkedin Profile: No
-
- I have made 100> posts
- Posts: 106
- Joined: Tue Sep 01, 2020 8:25 am
- 3
- Full Name: Nicolas LANDRIVON
- Company Details: Technodigit
- Company Position Title: Sales and Support
- Country: France
- Linkedin Profile: Yes
- Been thanked: 48 times
Re: Drone pick up against design cut/fill calculation
Hello Andrea,
Have you consulted the Help Center of Cyclone 3DR (Help menu or press F1)?
In the Analysis menu, Measure (first Icon), you can find a function called Cut and Fill, if this is what you are looking for.
This command calculates, according to a given axis (usually Z), the embankment and excavation of two mesh models, having or not the same contours (in this case the volume is approximated).
Feel free to contact directly CR Kennedy in Australia, there are very skilled people in Cyclone 3DR.
Regards
Nicolas L
Have you consulted the Help Center of Cyclone 3DR (Help menu or press F1)?
In the Analysis menu, Measure (first Icon), you can find a function called Cut and Fill, if this is what you are looking for.
This command calculates, according to a given axis (usually Z), the embankment and excavation of two mesh models, having or not the same contours (in this case the volume is approximated).
Feel free to contact directly CR Kennedy in Australia, there are very skilled people in Cyclone 3DR.
Regards
Nicolas L