Ι want to ask if there any filter in pointcab or in cloundcompare in order to clean the noise of the data taken from a P40,
after the cleaning etc. walls will be much cleaner and thicker ?
Any suggestions or other methods will be much apreciated.
Cleaning data from a P40
- steves01x
- V.I.P Member
- Posts: 544
- Joined: Tue Jul 21, 2015 3:58 pm
- 8
- Full Name: Steve Smith
- Company Details: Scanning
- Company Position Title: Surveyor
- Country: Scotland
- Linkedin Profile: Yes
- Has thanked: 31 times
- Been thanked: 57 times
Re: Cleaning data from a P40
Clean it manually in Cyclone - then you have full control to switch on/off each scan, use limit box, fence etc and any other tools that work for you depending on the job.
There are a few posts on the forum about it, i think quite a few of the guys use the region regrow tool for roads.
There are a few posts on the forum about it, i think quite a few of the guys use the region regrow tool for roads.
-
- V.I.P Member
- Posts: 544
- Joined: Fri Feb 24, 2017 10:47 am
- 7
- Full Name: Martin Graner
- Company Details: PointCab GmbH
- Company Position Title: Research and Development
- Country: Germany
- Linkedin Profile: No
- Has thanked: 160 times
- Been thanked: 175 times
- Contact:
Re: Cleaning data from a P40
↑ this ↑steves01x wrote: ↑Sat Jan 19, 2019 9:46 am Clean it manually in Cyclone - then you have full control to switch on/off each scan, use limit box, fence etc and any other tools that work for you depending on the job.
There are a few posts on the forum about it, i think quite a few of the guys use the region regrow tool for roads.
Besides a P40 shouldn't have much noise if the Registration was done quite good and the walls will look very thick in the PointCab Orthophotos if the point density is high, which is another given with the P40 & the right scanning resolution.