Cleaning data from a P40

Discuss all PointCAB related issues here
Post Reply
Ioannis
V.I.P Member
V.I.P Member
Posts: 189
Joined: Sun Jul 24, 2016 6:19 am
Full Name: Ioannis Papas
Company Details: techical office
Company Position Title: CEO
Country: EU
Skype Name: -
Linkedin Profile: Yes

Cleaning data from a P40

Post by Ioannis » Sat Jan 19, 2019 5:55 am

Ι want to ask if there any filter in pointcab or in cloundcompare in order to clean the noise of the data taken from a P40,
after the cleaning etc. walls will be much cleaner and thicker ?
Any suggestions or other methods will be much apreciated.

User avatar
steves01x
V.I.P Member
V.I.P Member
Posts: 274
Joined: Tue Jul 21, 2015 3:58 pm
Full Name: Steve Smith
Company Details: Scanning
Company Position Title: Surveyor
Country: Scotland
Linkedin Profile: Yes

Re: Cleaning data from a P40

Post by steves01x » Sat Jan 19, 2019 9:46 am

Clean it manually in Cyclone - then you have full control to switch on/off each scan, use limit box, fence etc and any other tools that work for you depending on the job.

There are a few posts on the forum about it, i think quite a few of the guys use the region regrow tool for roads.

VXGrid
I have made 70-80 posts
I have made 70-80 posts
Posts: 77
Joined: Fri Feb 24, 2017 10:47 am
Full Name: Martin Graner
Company Details: PointCab GmbH
Company Position Title: Research and Development
Country: Germany
Linkedin Profile: No
Been thanked: 1 time

Re: Cleaning data from a P40

Post by VXGrid » Mon Jan 21, 2019 7:31 am

steves01x wrote:
Sat Jan 19, 2019 9:46 am
Clean it manually in Cyclone - then you have full control to switch on/off each scan, use limit box, fence etc and any other tools that work for you depending on the job.

There are a few posts on the forum about it, i think quite a few of the guys use the region regrow tool for roads.
↑ this ↑

Besides a P40 shouldn't have much noise if the Registration was done quite good and the walls will look very thick in the PointCab Orthophotos if the point density is high, which is another given with the P40 & the right scanning resolution.

Post Reply

Return to “PointCAB”