We have a Leica HDS700, which is a Z+F 5010 under the grey and red paint. Can we use LC to run this scanner in the field? Is it a good option over just using the on-board controls?
We tend to use a traverse type workflow with our C10's & P20's, and generally with the HDS7000, but there's no target scan functions in the on-board software. We end up doing higher resolution scans than needed just to be able to get the targets reliably. I'm wondering if LC would solve this issue. We also end up doing all the target naming, etc. in the office in Cyclone, which tends to be quite tedious.
We currently do all our registrations in Cyclone, but it sounds like the LC process could be a good alternative. Has anyone tried both and prefer one over the other?
NAIK Consulting Group
New York, NY