Geomagic X: boundary fits generate gap

Discuss Geomagic software here.
Post Reply
raynonpo
I have made <0 posts
I have made <0 posts
Posts: 3
Joined: Wed May 13, 2015 3:01 am
8
Full Name: Sphantom
Company Details: Rapid Team Solution
Company Position Title: Application Engineer
Country: Malaysia
Linkedin Profile: No

Geomagic X: boundary fits generate gap

Post by raynonpo »

I was trying to use boundary fit on a 3D mesh sketch, however the results shows some gap in between the surface. is there any way to avoid generating the gap or is there any way to fix the gap?
You do not have the required permissions to view the files attached to this post.
PHughes
I have made 20-30 posts
I have made 20-30 posts
Posts: 25
Joined: Wed May 14, 2014 1:33 pm
9
Full Name: Patrick Hughes
Company Details: Self-Employed
Company Position Title: Metrology Engingeer
Country: UK
Linkedin Profile: Yes

Re: Geomagic X: boundary fits generate gap

Post by PHughes »

The gap is more than likely due to the curve network you are using, have you got any other images you can show me to get some more info. There are a few options when doing boundary fit which will help reduce the gap size. Are you sure boundary fit is the right tool for the job?
Post Reply

Return to “Geomagic”